search

Quantum Composers Sapphire 9200 Series Especificaciones Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 45
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
9200 Manual Version 1.2 | Quantum Composers Page 23
Channel Single Shot Function
The Single Shot mode generates a single pulse every time the unit is placed into active mode.
To use the channels’ single shot mode set the following parameters in the 9200 application:
Within the System section:
o Set the mode to Continuous.
o Set the desired Period (regulates rate of single shots)
Within the Channel section:
o Set the mode to Single Shot.
o Enter the required pulse width and delay. Repeat for each output channel.
o Enable the corresponding channels by clicking “Enabled” in the 9200 application.
Pressing the unit’s Run/Stop button will place the unit into active mode and generate a single
pulse on the enabled channels. Pressing the unit’s Run/Stop button again will take the unit
out of the active state (which will not produce a pulse). Continue this process for additional
single pulses. See “Output Examples” for a visual representation.
Channel Burst Mode
The burst mode generates a burst of pulses every time the unit is placed into active mode. To
use the channels’ burst mode set the following parameters in the 9200 application:
Within the System section:
o Set the mode to Continuous.
o Set the desired Period.
Within the Channel section:
o Set the mode to Burst.
o Set the Burst parameter to the number of pulses to produce during the on cycle
(‘N’).
o Enter the required pulse width and delay. Repeat for each output channel.
o Enable the corresponding channels by clicking “Enabled” in the 9200 application.
Pressing the unit’s Run/Stop button will place the unit into active mode and generate a burst of
pulses on the enabled channels. Pressing the unit’s Run/Stop button again will take the unit
out of the active state (which will not produce a burst). Continue this process for additional
bursts. See “Output Examples” for a visual representation.
Channel Duty Cycle Mode
The channel duty cycle mode will generate a stream of pulses on the channel level which will
repeat on for ‘N’ pulses and off or ‘M’ pulses. To generate the stated sequence of pulses set
the following parameters in the 9200 application:
Within the System section:
o Set the mode to Continuous.
o Set the desired Period.
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 44 45

Comentarios a estos manuales

Sin comentarios
Relacionado con productos y manuales para No Quantum Composers Sapphire 9200 Series
No Quantum Composers 8530 Series Manual de usuario   (10 paginas)
  • Ezee Desay MyNavi Comfy Air M.T.H. Electric Trains
  • InStep Asiento de coche LG Reproductores de mp3 / mp4 Zebra Pos / Impresoras Móviles Archos Decodificadores de tv BenQ Reproductores de mp3 / mp4
  • Samsung NP270E5E Denon D-M51DVS Lenovo 04W3949 Wika IS-21-F Cowon iAUDIO 10
  • Tripp Lite TLP810SAT El manual del propietario Sony VGN-S5XRP Manual de usuario CyberPower CP-MBC Manual de usuario Dish Network 3.1 Manual de usuario