Quantum-composers 9730 Series Manual de usuario descargar pdf (Pagina 37)

10-37

Channel Commands

Keyword

Command

Sub-

Command

Parameter

Range

Notes

:PULSe<n>

Contains commands to control the output pulse

generation. Valid suffix values depends on the number

of channels (ChA = 1, ChB = 2, etc). Command without

suffix refers to the currently selected logical instrument.

See INSTrument subsystem.

:TEMPerature

Query Only. Reads the temperature of the selected

channel.

:STATe

0/1 or

OFF/ON

Enables/Disables the output pulse for selected channel.

:WIDTh

5[us] –

100[s]

Sets the width or duration of the output pulse. Setpoint

resolution is 100ns.

:DELay

0 – 30[s]

Sets the time from the start of the T

period to the first

edge of the pulse. Resolution is 100 ns.

:BCOunter

2 - 250

Burst Counter. Sets the number of pulses to generate

when channel is in the BURST mode.

:AMPLitude

0.02 – 6[A]

Sets adjustable output level. Resolution is 1 mA.

:IADO

0 – 200[mA]

(+/-)

Sets dynamic current amplitude offset for the individual

channel. This value can be both positive and negative.

:PRETest

Subsystem. Contains commands for control and

monitoring of the channel pre-test parameters.

:MODe

0/1 or

OFF/ON

Enables/Disable the channel pre-test.

:MAXres

0.5 - 100

Sets the maximum valid resistance for pre-test in Ohms.

Resolution is 10 miliohms.

:MINres

0.1 - 100

Sets the minimum valid resistance for pre-test in Ohms.

Resolution is 10 miliohms.

:RESistance

Query Only. Returns the last measured resistance from

the pre-test.

:IMAX

3 -100[mA]

Sets the maximum test current for pre-test in miliamps.

Resolution is 100 us.

:POSTtest

Subsystem. Contains commands for control and

monitoring of the channel post-test parameters.

:TYPe

0,1,2

Sets the type of test to perform for the post test. Valid

parameters are: 0 – Standard, 1 – Outside,

2 – Outside Pre

:MODe

0/1 or

OFF/ON

Enables/Disable the channel post-test.

:MAXres

100 - 300

Sets the maximum valid resistance for post-test. (May be

disabled by writing a value of ‘0’). Resolution is 10

miliohms.

:MINres

3 - 100

Sets the minimum valid resistance for post-test in Ohms.

Resolution is 10 miliohms.

:RESistance

Query Only. Returns the last measured resistance from

the post-test.

:IMAX

3 – 100[mA]

Sets the maximum test current for post-test in miliamps.

Resolution is 100 us.

:ERRor

Query Only. Returns errors resulting from running the

pre or post tests on this channel. Refer to Testing Mode

Error Conditions for more information.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 49 50

Comentarios a estos manuales

Sin comentarios

Quantum-composers 9730 Series Manual de usuario Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores Quantum-composers 9730 Series