Quantum-composers AF910 Manual de usuario descargar pdf (Pagina 31)

AF910 Manual Version 1.4 Page 31

SO ####, SO? Sensor Offset. This is an objective specific offset that should be

set before data is collected off the sensor array. Each value is a

multiple of 8. The default is 2, which means that 2 x 8 = 16 pixels

of the linear array will be ignored before data is captured. This

command will allow the system to ignore a section of the array

data when determining the focus position. Values are from 0x0000

to 0x0020. A “?” will return the current offset value.

SP?, SP L?,

SP L ####

SP H?, SP H ####

Speed. Sets the motor clock speed output. A “?” will return the

active speed. The last speed changed is by default the active speed

and the motor will move at that speed if no other commands are

altered before the move command is sent. Step rates are 16 bit hex

values based on the following decimal calculations:

Rate = 20,000,000/(65,536-Value)

Value = 65,536 – (20,000,000/Rate)

The maximum step rate available is ~80KHz or a decimal value of

65300. Rates above 10KHz may have an error of ~10%. A “H”

parameter sets the high speed value that is used when the focus is

outside of the docking area. A “L” parameter sets the low speed

which is used once focus is inside the docking range.

SP M Speed Maximum. This command returns the current max speed

for the system. Values will range from 0x0000 to 0xFFFF.

SS System Status. Returns two bytes that indicate the status of

various system states.

Signal

Power Too

High

Signal

Power Too

Low

High

Sensor

Gain

Invalid

Data

Auto

Focus

Enabled

Docking

Range

In Focus

Range

In Focus

Area

Invalid

Power

Invalid

CoM

Invalid

Peak

Invalid

Intensity

Error

EMO

Status

Laser

Disabled

Auto

Motor

ST Stop. Stops motor movement. This will stop the motor and take it

out of auto motor mode if enabled.

VN Version Number. Returns the firmware revision number as a 3-

digit number followed by a release Alpha character in the format

“m.nnr”, where m = major version, n = minor version and r is the

release build. Ex: 1.22A.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38 39

Comentarios a estos manuales

Sin comentarios

Quantum-composers AF910 Manual de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores Quantum-composers AF910