Quantum-composers 9200 Series Manual de usuario descargar pdf (Pagina 24)

Page 24 9200 Manual Version 1.6 | Quantum Composers

Single Shot Mode

Pressing the unit’s Run/Stop button generates a single pulse with every press. Set the

following parameters in the 9200 application:

 Within the System section:

o Select Single Shot mode.

 Within the Channel section:

o Set channel mode to Normal.

o Enter the required pulse width and delay. Repeat for each output channel.

o Enable the corresponding channels by clicking “Enabled” in the 9200 application.

Pressing the unit’s Run/Stop button will now generate one pulse out of every enabled channel.

System Burst Mode Function

The Run/Stop button generates a stream of ‘N’ T

pulses, where the ‘N’ is specified by the

Burst parameter. The rate is specified by the Period parameter. Pressing the Run/Stop button

while the burst is in process will stop the output. After the burst has been completed, Pressing

the Run/Stop button will generate another burst of pulses. To generate a burst of pulses set

the following parameters in the 9200 application:

 Within the System section:

o Select mode to be Burst.

o Set the Burst Count parameter field to produce the number of pulses desired

o Set the desired Period.

 Within the Channel section:

o Set channel mode to Normal.

o Enter the required pulse width and delay. Repeat for each output channel.

o Enable the corresponding channels by clicking “Enabled” in the 9200 application.

Pressing the unit’s Run/Stop button will now generate the predefined burst of pulses out of

every enabled channel.

System Duty Cycle Function

The Run/Stop button starts a continuous stream of T

pulses, which repeats for ‘N’ pulses On

and ‘M’ pulses Off, where ‘N’ and ‘M’ are specified by the On/Off parameters respectively. The

rate at which the pulses are generated is controlled by the Period parameter. To generate a

stream of pulses which will repeat for ‘N’ pulses On and ‘M’ pulses, set the following

parameters in the 9200 application:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

Sin comentarios

Quantum-composers 9200 Series Manual de usuario Pagina 24