Quantum-composers 9500 Plus Series Manual de usuario descargar pdf (Pagina 48)

9500+ SCPI Command Summary

Keyword

Lower-Level

Keyword

Lower-Level

Keyword

Parameter

Std /

New

Comments

:PULSe [1 / 2 / n]

Std

Subsystem. Contains commands to

control the output pulse generation. Valid

suffix range depends on the number of

channels (ChA = 1, ChB = 2, ect).

Command without suffix refers to the

currently selected logical instrument. See

INSTrument subsystem.

:STATe

0 / 1 or OFF / ON

Std

Enables / Disables the output pulse for the

selected channel.

:WIDTh

0.000000004s -

1000s

Std

Sets the width or duration of the output

pulse.

:DELay

-1000s - 1000s

Std

Sets the time from the start of the T

period to the first edge of the pulse.

:SYNC

T0, CHA, CHB,

CHC, CHD, ect.

New

Selects the Sync Source.

:MUX

0 - 255

New

Selects which tmiers are enabled as

outputs for the current channel. The input

is a decimal representation of an 8 bit

binary number (example: 255 = 1111

1111)

:POLarity

NORMal /

COMPlement /

INVerted

Std

Sets the polarity of the pulse. For

NORMal operation, the second nominal

state is more positive that the first.

COMPlement and INVerted are aliases.

For both, the second state is more negative

than the first.

:OUTPut

New

Subsystem. Contains commands to

control the output mode.

:AMPLitude

2.00 - 20.00

New

Sets adjustable output level.

:MODe

TTL / ADJustable

/ 35V

New

Selects output AMPLitude mode:

TTL/CMOS, ADJustable, or 35 Volts.

:CMODe

NORMal /

SINGle / BURSt /

DCYCle

New

Channel Mode. Sets the channel pulse

series output mode.

:BCOunter 1 - 1000000 New

Burst Counter. Sets the number of pulses

to generate when the channel is in the

BURST mode.

:PCOunter 1 - 1000000 New

Pulse Counter. Sets the number of pulses

to generate during the on cycle of the Duty

Cycle mode.

:OCOunter 1 - 1000000 New

Off Counter. Number of pulses to inhibit

output during the off cycle of the Duty

Cycle mode.

:CGATe

DISable / LOW /

HIGH

New

Channel Gate Subsystem. Contains

commands to control using the gate input

to control the output channel.

:WCOunter

1 - 1000000

New

Sets the number of T

pulses to delay until

enabling the output.

NOTE: Output Amplitude is limited to 20V for both standard 9500+and 8510 units.

NOTE: 35V output mode only applicable on 9500+ 35V option.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 69 70

Comentarios a estos manuales

Sin comentarios

Quantum-composers 9500 Plus Series Manual de usuario Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores Quantum-composers 9500 Plus Series